Κώστας Φ.
Truth hurts. Here's a teddy bear.
- Μηνύματα
- 8.978
- Reaction score
- 894
Mόλις είδα πως ανέβασαν thread με περισσότερες πληροφορίες και οδηγό κατασκευής για το Manzanita, το Open Baffle που σας έλεγα εδώ (post #21). Το tweeter ήταν Vifa στην έκθεση αλλά το αρχικό σχέδιο παίζει με Seas? Who knows. Στην αρχή είχε πει Vifa πάντως.
To build each speaker you will need:
- Peerless SLS 830669 - 12" Woofer
- Seas 27TDFC tweeter
- Sledgehammer 12mH 15 gauge inductor
- 0.8 mH aircore inductor
- 12uF film capacitor
- 25 ohm 5W resistor
- Binding posts
- 3/4 wood for baffle, base and side wings. MDF or plywood, chipboard, etc.
Total project parts cost is under $150 US per side, excluding wood. Or less than $300 for the pair. The drivers and parts are easy to find in the US, and should be as easy to find in Europe. As long as you keep the crossover values the same, feel free to substitute your favorite brands. Obviously, you will use the same drivers!
There may be plenty of forum denizens who will poke holes in this design without ever building it. No worries, thats part of the DIY sport. Those who do build it will enjoy it, holes or not.
Why build this speaker? A few reasons:
- It sounds good.
- Its simple and easy to build.
- It plays well in an average size living room.
- It does not cost arm and a leg.
- Works well with most types of music.
- Very wide and deep soundstage.
- Easy to listen to low fatigue.
- Youve always wanted to try an open baffle design.
Why NOT build this speaker?
- Too simple. You need more of a challenge.
- Too cheap, you need to impress your friends.
- You like a hot midrange.
- You need ultimate finesse and flattest response.
- Your listening room is huge or tiny.
- Your amp is a 2 watt SET-DHT job.
- You would rather go to the beach. (I understand )
Διαβάστε περισσότερα εδώ.